OK, I got this feed working a little better
......I had to switch radios and change antennas.
I got it picking up off the back of the corner reflector antenna that is facing in the opposite direction. I use it for the other feeds, however it's still about 30 degrees off target for them. I could not hear the ground side of the transmissions using the intended yagi which is 45 degrees off target. The BC-350 radio normally used did not appreciate the change...so tried the Icom - no problem, I finally settled on using the Vertex VXA-220 until I
can make the needed repairs AGAIN! Gonna have to run a nut and bolt through the antennas and mast, that should work
RIGHT! If it doesn't then will just have to crank it down every weekend....like I have no life.
lifeless KEL
Author